A1 Vertaisarvioitu alkuperäisartikkeli tieteellisessä lehdessä
Effect of potassium hydrogen difluoride in zirconia-to-resin bonding
Tekijät: Hjerppe Jenni, Perea-Lowery Leila, Lassila Lippo VJ, Vallittu Pekka K
Kustantaja: Japanese Society for Dental Materials and Devices
Julkaisuvuosi: 2021
Journal: Dental Materials Journal
Tietokannassa oleva lehden nimi: Dental materials journal
Lehden akronyymi: Dent Mater J
ISSN: 0287-4547
eISSN: 1881-1361
DOI: https://doi.org/10.4012/dmj.2019-389
Verkko-osoite: https://doi.org/10.4012/dmj.2019-389
Tiivistelmä
The objective of this study was to compare potassium hydrogen difluoride (KHF2) etching for zirconia with commonly used surface roughening and chemical bonding methods (silane, MDP-monomer primer) for resin-based luting cement bonding to zirconia. Zirconia specimens were divided into six groups (n=10) according to surface treatment and bonding procedures, with and without thermocycling (6,000 cycles, 5–55ºC): 1) air-borne particle abrasion with alumina+MDP-monomer (ABP), 2) air-borne particle abrasion with silica-coated trialuminium trioxide+silane (ABPR-S) and 3) KHF2 etching+silane (ETC). Surface roughness and bond strength (SBS-test) for dry and thermocycled specimens were measured. SBS did not vary statistically between the dry groups, but thermocycling decreased the bond strengths of all the tested methods (p<0.05). After thermocycling, ABP had statistically significantly lower bond strength values compared to ABPR-S and ETC (p<0.05). Etching method with KHF2 did not provide better bonding capacity to previously introduced and commonly adopted bonding methods.
The objective of this study was to compare potassium hydrogen difluoride (KHF2) etching for zirconia with commonly used surface roughening and chemical bonding methods (silane, MDP-monomer primer) for resin-based luting cement bonding to zirconia. Zirconia specimens were divided into six groups (n=10) according to surface treatment and bonding procedures, with and without thermocycling (6,000 cycles, 5–55ºC): 1) air-borne particle abrasion with alumina+MDP-monomer (ABP), 2) air-borne particle abrasion with silica-coated trialuminium trioxide+silane (ABPR-S) and 3) KHF2 etching+silane (ETC). Surface roughness and bond strength (SBS-test) for dry and thermocycled specimens were measured. SBS did not vary statistically between the dry groups, but thermocycling decreased the bond strengths of all the tested methods (p<0.05). After thermocycling, ABP had statistically significantly lower bond strength values compared to ABPR-S and ETC (p<0.05). Etching method with KHF2 did not provide better bonding capacity to previously introduced and commonly adopted bonding methods.