A1 Refereed original research article in a scientific journal
Lidar estimates of birch pollen number, mass, and CCN-related concentrations
Authors: Filioglou, Maria; Tiitta, Petri; Shang, Xiaoxia; Leskinen, Ari; Ahola, Pasi; Patsi, Sanna; Saarto, Annika; Vakkari, Ville; Isopahkala, Uula; Komppula, Mika
Publisher: Copernicus GmbH
Publishing place: GOTTINGEN
Publication year: 2025
Journal: Atmospheric Chemistry and Physics
Journal name in source: Atmospheric Chemistry and Physics
Journal acronym: ATMOS CHEM PHYS
Volume: 25
Issue: 3
First page : 1639
Last page: 1657
Number of pages: 19
ISSN: 1680-7316
eISSN: 1680-7324
DOI: https://doi.org/10.5194/acp-25-1639-2025
Web address : https://doi.org/10.5194/acp-25-1639-2025
Self-archived copy’s web address: https://research.utu.fi/converis/portal/detail/Publication/491413841
The accurate representation of microphysical properties of atmospheric aerosol particles - such as the number, mass, and cloud condensation nuclei (CCN) concentration - is key to constraining climate forcing estimations and improving weather and air quality forecasts. Lidars capable of vertically resolving aerosol optical properties have been increasingly utilized to study aerosol-cloud interactions, allowing for estimations of cloud-relevant microphysical properties. Recently, lidars have been employed to identify and monitor pollen particles in the atmosphere, an understudied aerosol particle with health and possibly climate implications. Lidar remote sensing of pollen is an emerging research field, and in this study, we present for the first time retrievals of particle number, mass, CCN, giant CCN (GCCN), and ultragiant CCN (UGCCN) concentration estimations of birch pollen derived from polarization lidar observations and specifically from a PollyXT lidar and a Vaisala CL61 ceilometer at 532 and 910 nm, respectively.A pivotal role in these estimations is played by the conversion factors necessary to convert the optical measurements into microphysical properties. This set of conversion parameters for birch pollen is derived from in situ observations of major birch pollen events at Vehmasm & auml;ki station in eastern Finland. The results show that under well-mixed conditions, surface measurements from in situ instrumentation can be correlated with lidar observations at higher altitudes to estimate the conversion factors. Better linear agreement to the in situ observations was found at the longer wavelength of 910 nm, which is attributed to a combination of lower overlap and higher sensitivity to bigger particles compared to observations at 532 nm. Then, the conversion factors are applied to ground-based lidar observations and compared against in situ measurements of aerosol and pollen particles. In turn, this demonstrates the potential of ground-based lidars such as a ceilometer network with the polarization capacity to document large-scale birch pollen outbursts in detail and thus to provide valuable information for climate, cloud, and air quality modeling efforts, elucidating the role of pollen within the atmospheric system.
Downloadable publication This is an electronic reprint of the original article. |  |
Funding information in the publication:
The authors gratefully acknowledge the support of the Finnish Research Impact Foundation through the Tandem Industry Academia (TIA) program. Dust data and/or images were provided by the WMO Barcelona Dust Regional Center and the partners of the Sand and Dust Storm Warning Advisory and Assessment System (SDS-WAS) for Northern Africa, the Middle East, and Europe. We acknowledge the Aerosol, Clouds and Trace Gases Research Infrastructure (ACTRIS) for providing the dataset used in this study; the dataset was produced by the Finnish Meteorological Institute and is available on https://cloudnet.fmi.fi/ (last access: 15 September 2024).
