A4 Vertaisarvioitu artikkeli konferenssijulkaisussa
A study on use of wobble features in laser welding of low alloy steel joint with butt joint configuration
Tekijät: Kankala Timo, Salminen Antti
Toimittaja: Jan Frostevarg, Adrien Da Silva, Marie-Louise Palmblad, Lars Andersson
Konferenssin vakiintunut nimi: Nordic Laser Materials Processing Conference
Julkaisuvuosi: 2021
Journal: IOP Conference Series: Materials Science and Engineering
Kokoomateoksen nimi: 18th Nordic Laser Materials Processing Conference (18th NOLAMP) 18th-20th January 2022, Luleå, Sweden
Tietokannassa oleva lehden nimi: 18TH NORDIC LASER MATERIALS PROCESSING CONFERENCE (18TH NOLAMP)
Lehden akronyymi: IOP CONF SER-MAT SCI
Artikkelin numero: 012021
Sarjan nimi: IOP Conference Series: Materials Science and Engineering
Vuosikerta: 1135
Aloitussivu: 012021
Sivujen määrä: 10
ISSN: 1757-8981
eISSN: 1757-899X
DOI: https://doi.org/10.1088/1757-899X/1135/1/012021(external)
Verkko-osoite: https://iopscience.iop.org/article/10.1088/1757-899X/1135/1/012021(external)
Rinnakkaistallenteen osoite: https://research.utu.fi/converis/portal/detail/Publication/175077314(external)
Laser welding is modern digital welding process, which thanks to several advantages over traditional welding processes, is gaining ever growing role in manufacturing. The process has still some weaknesses. The better the beam quality the smaller the focal point, the actual welding tool, diameter is. Typically, because of this the welding of joints with lesser quality e.g. larger air gap is difficult or even impossible. So-called beam manipulation opens opportunities to deal with the problem. The dynamic beam manipulation gives opportunities to control the weld dimensions during the welding process by the requirements of individual locations of weld joint. This study used the two dimensional scanner to manipulate beam during welding with so called wobble function. Four different wobble configurations were tested in welding of low-alloyed steel with different joint qualities. The wobble typically made the welds wider, provided typically higher heat input and thus lowered the hardness of the joint. Wobble increased typically the root quality, but there are differences between different wobble parameters. It was possible to weld joints with wider air gaps in the selected material thickness, but the wider air gap and wobble caused finally, when wide enough the sagging of the joint.
Ladattava julkaisu This is an electronic reprint of the original article. |  |
