A4 Vertaisarvioitu artikkeli konferenssijulkaisussa
The influence the uncut chip thickness has on the stagnation point in orthogonal cutting
Tekijät: Agmell M, Johansson D, Laakso SVA, Ahadi A, Stahl JE
Toimittaja: José Outeiro, Gérard Poulachon
Konferenssin vakiintunut nimi: CIRP Conference on Modelling of Machining Operations
Julkaisuvuosi: 2017
Journal: Procedia CIRP
Kokoomateoksen nimi: 16th CIRP Conference on Modelling of Machining Operations (16th CIRP CMMO)
Tietokannassa oleva lehden nimi: 16TH CIRP CONFERENCE ON MODELLING OF MACHINING OPERATIONS (16TH CIRP CMMO)
Lehden akronyymi: PROC CIRP
Sarjan nimi: Procedia CIRP
Vuosikerta: 58
Aloitussivu: 13
Lopetussivu: 18
Sivujen määrä: 6
ISSN: 2212-8271
DOI: https://doi.org/10.1016/j.procir.2017.03.183
Tiivistelmä
The effect of cutting data on the stagnation zone of a machining operation is of great interest since it governs the material flow around the cutting edge. The material flow has a significant influence on the mechanical properties of the machined surface. This paper presents a numerical model that is able to determine the effect that the uncut chip thickness has on the stagnation zone and the connection between the stagnation zone and the deformation layer in the machined subsurface. (C) 2017 The Authors. Published by Elsevier B.V.
The effect of cutting data on the stagnation zone of a machining operation is of great interest since it governs the material flow around the cutting edge. The material flow has a significant influence on the mechanical properties of the machined surface. This paper presents a numerical model that is able to determine the effect that the uncut chip thickness has on the stagnation zone and the connection between the stagnation zone and the deformation layer in the machined subsurface. (C) 2017 The Authors. Published by Elsevier B.V.
Turun yliopiston Tutkimustietojärjestelmän portaali